DOI:
铜业工程:2020(1):6-10
本文二维码信息
码上扫一扫!
某微细粒金矿石浮选试验研究
(江西铜业集团有限公司武山铜矿,江西 瑞昌 332204)
Experimental Study on Flotation of a Fine Grain Gold Ore
(Wushan Copper Mine, Jiangxi Copper Corporation Limited, Ruichang 332204, Jiangxi, China)
摘要
图/表
参考文献
本刊相似文献
All Journals 相似文献
All Journals 引证文献
本文已被:浏览 1653次   下载 2874
投稿时间:2019-11-21    
中文摘要: 云南某金矿石含金 3.39g/t,含硫 1.19%,金的嵌布粒度极其微细,基本小于 10μm,主要充填于毒砂和黄铁矿中。以异丁基黄药和 GYM 为组合捕收剂进行了浮选试验研究,浮选工艺参数为 :磨矿细度 -0.074mm 占 98%、捕收剂用量为 300g/t、调整剂碳酸钠用量 1250g/t、抑制剂水玻璃用量 2000g/t、活化剂硫酸铜用量 120g/t,经一次粗选、四次精选和两次扫选闭路浮选流程,获得了金精矿金品位 56.61g/t、金回收率81.49% 的选别指标。尾矿分析结果显示,部分单体金未充分解离,造成尾矿金品位较高。
Abstract:A gold ore in Yunnan contains 3.39g/t of gold and 1.19% of sulfur. The gold has a very fine grain size, which is less than 10μm, and is mainly filled in arsenopyrite and pyrite. The flotation experiment was carried out with isobutyl xanthate and GYM as the combined collector. The flotation process parameters were: grinding fineness -0.074mm, 98%, collector amount, 300g/t, adjusting agent,sodium carbonate. The dosage of 1250g / t, the inhibitor water glass dosage 2000g / t, the activator copper sulfate dosage 120g / t, after a rough selection, four selections and two sweeps of closed-circuit flotation process, obtained gold concentrate gold grade 56.61 g/t, gold recovery rate of 81.49% of the selection indicators. The tailings analysis showed that some of the monomer gold was not fully dissociated,resulting in a higher tailing gold grade.
文章编号:202001002     中图分类号:TD954
基金项目:
引用文本: 柯圣钊,丘世澄.某微细粒金矿石浮选试验研究[J].铜业工程,2020,(1):6-10